Spectrum analyzers, signal generators, and EMI receivers trusted by RF engineers across 95 countries. Every instrument calibrated to traceable international standards.
Signal analysis, generation, and compliance testing instruments designed to meet the most demanding measurement challenges in RF, microwave, and wireless communications.
Our instruments are designed by engineers who understand that measurement uncertainty directly impacts your design margins, compliance results, and time to market.
Explore Our TechnologyUp to 800 MHz real-time analysis bandwidth with 100% probability of intercept. Capture transient signals and frequency-hopping transmissions that conventional swept analyzers miss entirely.
ISO/IEC 17025 accredited calibration laboratory. Every measurement result traces back to national metrology institute standards through an unbroken chain of comparisons with documented uncertainty budgets.
Signal generators achieve phase noise of -152 dBc/Hz at 1 GHz (20 kHz offset), enabling precise modulation quality measurements for 5G NR, LTE-Advanced, and satellite communication waveforms.
Active contributors to IEEE, IEC, ETSI, and 3GPP standardization committees. Our instruments are referenced in international measurement standards and accreditation frameworks.
Contributing to IEEE 802.11 and 5G measurement standards
EMC measurement methods and instrumentation standards
5G NR conformance test specification development
Accredited calibration laboratory
5G NR, LTE-A, and satellite communication signal analysis. Base station transmitter testing and interference hunting with handheld spectrum analyzers across 698 MHz to 6 GHz bands.
Radar cross-section measurements, EW signal environment simulation, and MIL-STD-461 compliance testing. Instruments qualified to MIL-STD-810 for field deployment environments.
CISPR 25 and ISO 11452 automotive EMC testing. Pre-compliance and full-compliance conducted and radiated emissions measurement from components through vehicle-level assessments.
FCC, CE RED, and TELEC certification test solutions. Automated regulatory compliance test sequences for Wi-Fi 6E/7, Bluetooth 5.x, UWB, and cellular IoT devices.
On-wafer S-parameter characterization up to 110 GHz. Load-pull measurements and non-linear device modeling for MMIC and RF SoC development cycles.
University research lab instrument packages with remote access capability. Teaching-oriented spectrum analyzers and signal generators with guided measurement workflows.
A European mobile network operator deploying 3,500 5G NR base stations across urban and suburban cells needed to verify transmitter output power, occupied bandwidth, and adjacent channel leakage ratio (ACLR) at each site within a 6-month rollout window. Using our handheld spectrum analyzers with automated 3GPP conformance test sequences, field engineers completed site verification in under 45 minutes per cell — compared to 2+ hours with previous manual measurement workflows. The automated pass/fail reporting reduced documentation errors by eliminating manual data transcription across 3,500 site acceptance reports.
An EV powertrain component manufacturer in the automotive tier-1 supply chain was experiencing 30% failure rates at external EMC test houses, with each failed test cycle costing approximately 4 weeks and $15,000 in re-testing fees. After deploying our EMI test receivers and CISPR 25 test software in-house, the engineering team identified and resolved emissions issues during the design phase. Pre-compliance screening reduced external test house failures to under 5%, saving an estimated 16 weeks of development time per product line annually.
Our application engineers average 15 years of RF measurement experience. Tell us your challenge.
